At the paint spraying station, there are two types of things in the air at the same time: one is paint mist, visible small particles; One type is the solvent gas evaporated from the paint, which cannot be seen and can only be smelled when approached. The processing paths for particles and gases are different, and masks that only block particles cannot solve the latter type. This is an area that spray painters often overlook when choosing masks.

First, let's take a look at the paint mist. Paint mist belongs to particulate matter, but it also depends on the type of paint: water-based paint and latex paint are mainly composed of non oily particles, and KN grade can handle it; Oil paint and some fast drying paint spray droplets with oil, and KP grade should be selected. FangdunKP100 filter cotton 2907P, with an activated carbon layer added to the filter material, has a filtration efficiency of not less than 99.97% for 0.075 micron oily particles according to the detection standard, while also taking into account some odors; KN100 can be used for non oily working conditions, and the filtration efficiency should not be less than 99.97% according to the testing standard.

Let's take another look at solvent gases. Volatile compounds such as benzene, esters, and ketones belong to gases and cannot be blocked by filter cotton. Therefore, a filter cartridge is required. Fangdun5000 series. The common type of spray paint is type A, and the specific composition depends on the MSDS label of the paint, not on experience.
In terms of the mask body, the food grade liquid silicone half mask is interchangeable with the mask body and filter material; S size is suitable for thin face shapes (reference can be made for those weighing less than 73 kilograms). Silicone veneers are relatively soft, and the pressure is relatively light when worn for a long time, provided that the size is correct and the nose clip is pressed in place.

Two practical points. One is the tightness check: after wearing it, cover the air inlet of the filter material with your palm, gently inhale, and keep the cover slightly inward for a few seconds; If there is a leak, readjust the headband or change the size. The second is the replacement rhythm: the surface of the filter cotton has obvious paint accumulation, the breathing has become heavier, or it needs to be replaced when it reaches the distribution cycle; Do not wait until you feel uncomfortable before replacing the filter box, as it may smell paint or have expired according to the manufacturer's label.

Sealed paint spraying rooms and baking paint rooms rely on ventilation and exhaust to reduce concentration, with masks as the second layer; When the oxygen content is below 18% in poorly ventilated spaces such as tank walls and trenches, long tube respirators or gas supply equipment should be used instead. Filter masks are not suitable in this environment. The specific values such as respiratory resistance shall be subject to the accompanying inspection report.
English



